Also if i connect the monitors direct to the audio interface i get decent playback its only when i try to run the monitors/headphones via the mixer.Ĭlearly there is an issue with the way ive set the cables up. With this set up if i plug headphones into the audio interface i get clear decent playback, however if i plug the phones into the "phones" on the mixer i get the same muddy/underwater results. Ive adjusted all volume controls on the mixer/audio interface/speakers etc with the same results. Ive tried using ts to ts cables into the speakers as well with the same results.I have also tried trs (stereo) leads into the monitors as well. I dont have any problems recording into my DAW with this set up its just the playback which sounds like its playing under water. This was following advice from several youtube videos.
I then connect the "out" on my mixer to two line outputs on the rear of the audio interface using a twin rca (from the mixer) to ts cables (into the audio interface outputs 1 & 2 on the audio interface.įinally i plug a twin ts lead from the control room out into my monitors (rca inputs). (Also have tried trs stereo leads for this connection with the same results). My mixer "main out" is unbalanced so i use 2 ts (mono) cables from my mixer into the 2 inputs on the audio interface which is set to "line" input. Plugging in headphones/monitors to the audio interface direct works fine with the same set up but not when i try to route them through the mixer: In fact, i hear nothing until its quite high. I'm having real problems connecting my mixer to my audio interface and getting playback via my monitors/headphones.Ĭonnecting via the following method all i get is muddy very quiet playback even on max volume. Hope this is the correct section to ask this, if not please advise.
0 kommentar(er)
